SeaDawg3
Decky
Last Activity: 06-30-2021, 06:55 PM
Joined: 07-01-2015
-
this is the only civilized place.
-
...
Leave a comment:
-
no worries, lol... the bottom line is we just don`t know until its all hooked up. Im picking up the pump today, and my speed shop has a regulator in stock......Leave a comment:
-
a response from Cliff from my thread over there:
"After reading from several sources the Rochester needs 4-5 psi and then...Leave a comment:
-
true that, but if the rebuilder did their job and installed marine specific parts in this reman, thn Cliff ruggles says the Rocky could take that all...Leave a comment:
-
For shits n giggles I have a new Holley marine pump on the way 6.5 -8.0 psi. I`ll set that up and go from there... I have a hand full of new fittings...Leave a comment:
-
I just can not believe he is still in office, what a bafoon, where is oswald???
I hope all the woke bozo`s are happy now......Leave a comment:
-
check this out, here is what Cliff Ruggles had to comment on my remanufactured carb, after posting a few question on some requirements for the Rochester....Last edited by SeaDawg3; 06-27-2021, 09:05 PM.Leave a comment:
-
yep and yep. I use a mini Mr Gasket pump to pull fuel and it showed good volume, no restriction, for some reason Im just not jiggy with removing the pick...Leave a comment:
No activity results to display
Leave a comment: