Mercury Mirage with a Yamaha F300

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Mercury Mirage with a Yamaha F300

    Hi Ken.....have a customer with a pressed in hub Mercury Mirage 17P for a Yamaha F300. I believe that prop fits the splines on that prop shaft. Do you know what prop hardware would be used? I am guessing a Merc thrust washer 853948T and the standard Yamaha F300 prop hardware kit that go on after the prop is slid on? Thanks! Andy
    Andrew Munao Jr
    Yamaha Sales/Tech Support, SIM Yamaha
    888-231-2392 | [email protected] | simyamaha.com

  • #2
    The same thrust washer from the Flo Torq 2 hub kit for the yamaha. Yes, that part number is right. 853948T
    If its the old style rubber hub Mirage, it should have the Mercury rear spacer that goes on after the prop.
    quicksilver part number.
    12-31211Q03 https://www.ebay.com/itm/NEW-Quicksi...-/161994024430
    then just the stock prop nut and cotter pin.

    Ken Reeves
    [email protected]
    941-735-5808

    Comment


    • #3
      Thanks Ken!
      Andrew Munao Jr
      Yamaha Sales/Tech Support, SIM Yamaha
      888-231-2392 | [email protected] | simyamaha.com

      Comment

      Working...
      X